Klarstein OSTFRIESE Manual De Instrucciones página 17

Operation of your Kettle
1. Open the lid by pulling up the lid knob; fill with the desired amount of water
to the water kettle. Always fill the kettle between the minimum and maximum
marks. Too little water will result in the kettle switching off before the water
has boiled. NOTE: Do not fill the water over the maximum level, as water may
spill out of the spout when boiling. Ensure that the lid is firmly in place before
connecting the power cord to the outlet.
2. Connect the plug into a power outlet. Press the on/off switch button " on the
handle and the kettle starts to boil the water. The LED lights inside the kettle
will illuminate red. The kettle will switch off automatically once the water has
boiled. You can shut off the power by pressing the switch button again at any
moment during boiling water. NOTE: Ensure that the lid is firmly closed.
3. Take the plug out of the outlet. Lift the kettle then pour the water. NOTE:
operate carefully when pouring the water from your kettle as boiling water
will scald.
4. The kettle will not re-boil until the switch is pressed again. Allow to cool for
30~40 seconds before reope- ning to boil water. NOTE: Ensure power supply is
turned off when kettle is not in use.
5. Should you accidentally allow the kettle to operate without water; the boil-dry
protection will automatically switch it off. If this occurs, allow the kettle to cool
before filling with cold water and re-boiling.
Temperature showing by LED display
Press the temperature control button to choose your desired water temperature
50°C, 70°C, 80°C or 90°C, the corresponding indicator light on handle will be on.
Then press the on/off switch button ", the kettle will start heating with different
colour LED lights inside. When the desired temperature reaches, the kettle will
stop heating and send out beep sounds.
50°C: Green light.
70°C: Blue light.
80°C: Purple light.
90°C: Yellow-green light.
EN
17