Turning Off The Control Unit; Safety And Radio Frequency Information; Preventive Maintenance; Cleaning - Codman MedStream 91-4205 Manual Del Usuario

Turning Off the Control Unit

Press and hold the Power/Escape button for three seconds to turn off the
control unit.
If you do not manually turn off the control unit after each use, the control unit
enters the power saver mode to conserve battery power (if the power saver
mode has not been deactivated). After 10 minutes of inactivity, the control
unit enters a lower power mode. Although the screen is turned off, the control
unit is still on. To turn the screen back on, press the Power/Escape button.
After an additional 15 minutes in the power saver mode, the control unit will
power off.
Instructions for deactivating the power saver mode appear in the MedStream
Infusion System Programming Guide. When the power saver mode is
deactivated, a message regarding this status will appear when the power
is turned on.

Safety and Radio Frequency Information

The MedStream Control Unit (catalog no. 91-4205) complies with the
requirements of:
IEC/EN/UL/CAN/CSA-C22.2 No. 60601-1 Medical Electrical Equipment -
part 1: General requirements for safety
IEC/EN/UL/CAN/CSA-C22.2 No. 60601-1-1 Medical Electrical Equipment -
Safety Requirements for Medical Electrical Systems
IEC/EN/UL/CAN/CSA-C22.2 No. 60601-1-2 Medical Electrical Equipment -
Electromagnetic compatibility
IEC/EN/UL/CAN/CSA-C22.2 No. 60601-1-4 Medical Electrical Equipment -
Programmable Electrical Medical Systems
47 CFR Parts 1, 2, and 15 Federal Communications Commission Rules
and Regulations
ICES-003 Interference-Causing Equipment Standard for Digital Apparatus
RSS 102 Radio Frequency Exposure Compliance of Radiocommunication
Apparatus (All Frequency Bands)
RSS 210 Low-power License-exempt Radiocommunication Devices (All
Frequency Bands): Category I Equipment
EN 301 489 Electromagnetic compatibility and Radio spectrum Matters
(ERM); ElectroMagnetic Compatibility (EMC) standard for radio equipment
and services
EN 300 330 Electromagnetic compatibility and Radio spectrum Matters
(ERM) - Short Range Devices (SRD); Radio equipment in the frequency
range 9 kHz to 25 MHz and inductive loop systems in the frequency range
9 kHz to 30 MHz
6
206102-001-D.indb 6 206102-001-D.indb 6
1999/519/CE Council Recommendation of 12 July 1999 on the Limitation of
Exposure of the General Public to Electromagnetic Fields (0 Hz to 300 GHz)
1999/5/EC Radio Equipment and Telecommunication Equipment Mutual
Recognition of Conformity

Preventive Maintenance

The control unit performs a self-diagnostic test each time the power is turned
on. No user maintenance is required.

Cleaning

Cleaning the Outer Case
Clean the outer case of the control unit with a water-dampened cloth. Do not
allow excessive moisture into the control unit.
CAUTION: Do not immerse the control unit in liquid. Do not clean the
programmer with aromatic or chlorinated hydrocarbons.
Cleaning the Display
Do not use any cleaning agents on the display. Clean the display only with
a soft, dry, lint-free cloth.
Note: Scratches on the display can adversely affect device operation by
interfering with display option selection. If scratches are present, the control
unit might need to be repaired or replaced.
Cleaning the Antenna
Clean the exterior surfaces of the antenna with a damp sponge or soft cloth
moistened with water, mild detergent or alcohol. Prevent liquid from entering
any system components.

Disinfection

To disinfect, wipe the outer case of the control unit with an
antibacterial solution.

Sterilization

CAUTION: Do not sterilize the control unit or the battery charger.
The control unit, USB cable, battery charger and hardware key are nonsterile.
To use the control unit and accessories in the sterile field, wrap in sterile
plastic drapes.
9/15/2014 6:26:37 PM 9/15/2014 6:26:37 PM