Fein AFMT12 Instrucciones De Uso página 13

All manuals and user guides at all-guides.com
OBJ_BUCH-0000000180-001.book Page 13 Wednesday, April 15, 2015 8:23 AM
Changing the tool (AFMT12Q) (figure 4).
Possible overloading of the vibration
damping with especially heavy accesso-
ries!
When using the large round sanding plate
(No. 63806195020, Ø115 mm) or the cleaning
kit for tile joints (No. 63719011020), the
damping system can be subject to overload
due to the heavy weight of the accessories.
This becomes apparent through unpleasant
and very intense vibration of the machine.
Corrective action: Reduce the speed of the
machine to electronic level 2.
Due to the then possibly reduced working
progress, the machine is only suitable to a
limited extent for above mentioned accesso-
ries.
The application tool can be offset in 45° steps
and fastened in the most favorable working
position.
Protect your hand and fingers
CAUTION
against bruising when locking
the clamping lever. The clamping lever snaps
back vigorously by means of spring force.
Release the clamping lever and tilt it to the
stop.
Pull out the fastening element.
Clean the tool holder, the application tool and
the fastening element.
Insert the application tool accurately into the
star-shaped tool holder. Pay attention that the
application tool is mounted flush.
Firmly press in the fastening element to
the stop. Then lock the clamping lever.
Fig. 4
Fastening element
Application tool
Tool holder
180°
Quick-clamping lever
en
13