Fein AFMT12 Instrucciones De Uso página 14

All manuals and user guides at all-guides.com
OBJ_BUCH-0000000180-001.book Page 14 Wednesday, April 15, 2015 8:23 AM
en
14
Working instructions.
Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Do not use accessories not specifically intended and recommended for this power tool by FEIN.
The use of non-original FEIN accessories can lead to overheating of the power tool and destroy
it.
For each job, use only the FEIN application tool released and intended for the
CAUTION
respective application.
Switching on and off (figure 5).
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power
tool.
Guide the power tool toward the work
piece only when switched on.
Switching on:
Push the switch toward the front (I).
Switching off:
Push the switch toward the rear ().
Setting the oscillating frequency
(figure 6).
Adjust the oscillating frequency infinitely vari-
able with the dial control.
Increasing the oscillating frequency:
Turn the dial control in clockwise direction.
Decreasing the oscillating frequency:
Turn the dial control in counterclockwise
direction.
Fig. 5
On/Off switch
Fig. 6
Thumbwheel for
pre-selection
of oscillating
frequency
6
5
4
3
2
1