Fein AFMT12 Instrucciones De Uso página 15

All manuals and user guides at all-guides.com
OBJ_BUCH-0000000180-001.book Page 15 Wednesday, April 15, 2015 8:23 AM
Notes on sanding.
Press the power tool with the sanding sheet
briefly and firmly against a flat surface and
briefly switch the power tool on. This pro-
vides for good adhesion and prevents prema-
ture wear.
When only one tip or corner of the sanding
sheet is worn, it can be removed again and
reattached, turned by 120°.
Work with the entire surface of the sanding
plate, not only with the tip. Select a high oscil-
lating frequency. Sand with continuous motion
applying moderate pressure. Applying high
pressure does not increase the rate of
removal, it only wears off the sanding sheet
faster.
Handling the battery.
Operate and charge the battery only within
the battery operating-temperature range of
0°C – 45°C (32°F – 113°F). At the beginning
of the charging procedure, the battery tem-
perature must be within the battery operat-
ing-temperature range.
Battery charge-control indicator
(figure 7).
Press the button to activate the LED indica-
tion.
LED indicator Meaning Activity
1 – 4 green Percentage Operation
LED of charge
condition
Continuous Battery is Charge battery
red light almost
empty
Red flashing Battery is Bring the battery
light not ready into the battery
for opera- operating-tem-
tion perature range,
then charge
The real percentage of the battery charge
condition is only indicated when the power
tool motor is stopped.
The electronics automatically switch off the
motor prior to the battery being deep dis-
charged.
Notes on sawing.
Select a high oscillating frequency. Round saw
blades can be released and clamped offset
again, to allow for uniform wearing off.
Notes on scraping.
Select a moderate to high oscillating fre-
quency.
Fig. 7
LED indication on battery
en
15
Button
100 %
75 %
50 %
25 %
0 %