Power Connections; Ground Terminal - Sony XM-5ES Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Power Connections

+12 V
REMOTE
less than 450 mm (17
Fuse (160 A)
*1 If you have the factory original or some other car audio
unit without a remote output for the amplifier, connect
the remote input (REMOTE) terminal to the ACC power
supply. In high level input connection, the amplifier can
also be activated without the need of a REMOTE
connection. However, this function is not guaranteed for
all car audio units.
*2 Ground (earth) to the car chassis.
+12 V terminal
• Connect the +12 V power supply lead to the +12 V
terminal only after all the other connections have
been completed.
• Use a +12 V power supply lead with a 160 A fuse
attached.
• During full-power operation, a current of more
than 160 A will run through the system. Therefore,
make sure the leads to be connected to the +12 V
terminal are at least 0-Gauge (AWG-1/0) or have a
sectional area of more than 55 mm² (2
• All power leads connected to the positive battery
post should be fused within 450 mm (17
the battery post before they pass through any
metal.
• Make sure the leads connecting from the car
battery to the metal point on the car chassis are at
least of a lead gauge equal to that of the +12 V
power supply lead connected from the battery to
the amplifier.
• Make sure the leads connecting from the car
battery to the metal point on the car chassis are
not more than 0-Gauge (AWG-1/0) or have a
sectional area of 55 mm² (2
of a lead gauge equal to that of the +12 V power
supply lead connected from the battery to the
amplifier.
GROUND
to a metal point
on the car chassis
REMOTE
OUT*
1
3
/
in)
4
5
/
in²).
16
3
/
in) of
4
5
/
in²), and at least
16

GROUND terminal

• Be sure to connect the ground (earth) lead
securely to a metal point on the car chassis. A
loose connection may cause the amplifier to
malfunction.
• During full-power operation, a current of more
than 160 A will run through the system. Therefore,
make sure the leads to be connected to the
GROUND terminal are at least 0-Gauge (AWG-1/0)
or have a sectional area of more than 55 mm²
(2
5
/
in²).
16
REMOTE terminal
• To turn on the amplifier using a dedicated remote
turn-on lead, set the TURN-ON switch to
"REMOTE", then connect the remote output
(REMOTE OUT) of your car audio unit to the
REMOTE terminal.
• When using a car audio unit without a remote
output (REMOTE OUT) for the amplifier, connect
the REMOTE terminal to the ACC power supply of
your car or use the signal sensing turn-on setting
instead.
• Use a remote turn-on lead with a thickness from
AWG-8 to AWG-18 or with sectional area from
8.4 mm² (
11
/
in²) to 0.82 mm² (
32
Notes on using high-level sensing turn-on
settings
• In high level input connection, the amplifier can
also be activated without the need of a REMOTE
connection. However, this function is not
guaranteed for all car audio units.
• By setting the TURN-ON switch to "SIGNAL", the
amplifier operates automatically when a turn-on
signal is received from the INPUT connector.
1
/
in²).
16
11
GB

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido