MSW Motor Technics MSW-MIB-R-380 Manual De Instrucciones página 23

3.2.
Preparation and service
DEVICE PLACEMENT
Keep the device away from any hot surfaces. Remember that the air pressure in the
chambers does not exceed the recommended range. Use the inflatable boat only in
accordance with its intended use and design category!
3.2.1 ASSEMBLY OF THE DEVICE
IMPORTANT: before assembly, make sure that the surface on which the inflatable
boat will be mounted is free of any sharp objects or edges that could damage its
sheathing.
a) Take the inflatable boat out of its packaging and unfold it flat.
b) Place the wedge-shaped bottom panel inside the inflatable boat at the bow,
ensuring that the panel opening coincides with the keel air valve.
c) Insert the numbered rectangular panels one by one (numbers facing upwards)
and finally lift them together and join their sides leading along the boat sides
with special slats - slide them in.