Milwaukee M18 FUEL Manual página 5

OPERATION
WARNING
safety goggles or glasses with side shields.
Starting, Stopping and Controlling Speed
WARNING
bystanders 50' away during use. Objects may be
thrown or ricochet in all directions.
The tool can be controlled two ways - by the trigger
or by the Variable Speed Lock-On sliding lever.
To start the tool, grasp the handle firmly
and pull the trigger or push the sliding
lever forward.
To vary the speed, increase or decrease
the pressure on the trigger or move the
sliding lever forward or back. The further
the trigger is pulled or the sliding lever is
pushed, the greater the air flow.
To lock on the tool, use the Variable
Speed Lock-On sliding lever.
To stop the tool, release the trigger or
pull back the sliding lever completely.
Using the Blower
WARNING
move all debris and hard objects such as rocks,
glass, wire, etc. that can ricochet, be thrown, or
otherwise cause injury or damage during operation.
Hold the tube 5"-6"
above the ground.
Slowly sweep the
blower from side to
side.
Move forward slowly,
working the debris
into a pile.
To reduce the risk of
injury, always wear
Do not point tool at self
or bystanders. Keep
On
Off
Inspect the area before
using the blower. Re-
MAINTENANCE
WARNING
the charger and remove the battery pack from
the charger or tool before performing any main-
tenance. Never disassemble the tool, battery
pack or charger. Contact a MILWAUKEE service
facility for ALL repairs.
Maintaining Tool
Keep your tool, battery pack and charger in good
repair by adopting a regular maintenance program.
Inspect your tool for issues such as undue noise,
misalignment or binding of moving parts, breakage of
parts, or any other condition that may affect the tool
operation. Return the tool, battery pack, and charger
to a MILWAUKEE service facility for repair. After six
months to one year, depending on use, return the
tool, battery pack and charger to a MILWAUKEE
service facility for inspection.
If the tool does not start or operate at full power with
a fully charged battery pack, clean the contacts on
the battery pack. If the tool still does not work prop-
erly, return the tool, charger and battery pack, to a
MILWAUKEE service facility for repairs.
WARNING
damage, never immerse your tool, battery pack
or charger in liquid or allow a liquid to flow inside
them.
Clean dust and debris from any vents. Keep tool
clean, dry and free of oil or grease. Use only mild
soap and a damp cloth to clean, since certain clean-
ing agents and solvents are harmful to plastics and
other insulated parts. Some of these include gasoline,
turpentine, lacquer thinner, paint thinner, chlorinated
cleaning solvents, ammonia and household deter-
gents containing ammonia. Never use flammable or
combustible solvents around tools.
For repairs, return the tool, battery pack and charger
to the nearest authorized service center.
ACCESSORIES
WARNING
be hazardous.
For a complete listing of accessories, go online to
www.milwaukeetool.com or contact a distributor.
SERVICE - UNITED STATES
1-800-SAWDUST
Monday-Friday, 7:00 AM - 6:30 PM CST
www.milwaukeetool.com
or visit
Contact Corporate After Sales Service Technical
Support with technical, service/repair, or warranty
questions.
Email: metproductsupport@milwaukeetool.com
B e c o m e a H e a v y D u t y C l u b M e m b e r a t
www.milwaukeetool.com to receive important
notifications regarding your tool purchases.
5
To reduce the risk of
injury, always unplug
To reduce the risk of
personal injury and
Cleaning
Repairs
Use only recommended
accessories. Others may
(1.800.729.3878)