Installing The Double Fan Hood - Dacor DHDU990W/DA Serie Instrucciones Para Instalación

Installation
WARNING
ELECTRICAL SHOCK HAZARD.
WARNING
ELECTRICALLY GROUND FAN.
CONNECT GROUND WIRE TO GREEN AND YELLOW
GROUND WIRE IN TERMINAL BOX. FAILURE TO DO SO
CAN RESULT IN DEATH OR ELECTRICAL SHOCK.

Installing the double fan hood

1. Using 2 or more people, hang the fan housing on 2
mounting screws through the mounting slots on back
of hood.
C
2. Mark with a pencil the lower mounting holes
location (C).
3. Uninstall the fan housing, and drill ³⁄₁₆" (4.8 mm) pilot
holes at marked locations.
4. Hang the fan housing again on 2 upper mounting
screws (A).
5. Level the fan housing and tighten upper mounting
screws (A).
6. Install 2 - 5 x 45 mm lower mounting screws and
tighten (C).
Use the optional wall anchors if needed.
16 ENGLISH
A. Mounting screws
B. Mounting slots
C. Low mounting screws
7. Connect green (or bare) ground wire from home
power supply to yellow-green ground wire (E) in
terminal box using UL listed wire connectors.
8. Tighten strain relief screw.
9. Install terminal box cover.
10. Reconnect power.
7. Using 2 or more people, lift the hood base beneath
the motor housing. Insert the hood base pins into the
housing lower slots. Once the four pins are already
inserted, the hood base stands hanging.
8. Release the base connector wire from the strap. Plug
with the fan housing wire connector.