Carrying Out A Breath Sample - Dräger Alcotest 4000 Instrucciones De Uso

Time format
A cursor pre-selects a time format. Press briefly on the button to change the
position of the cursor in order to select your needed time format. If the cursor
selects the needed time format please hold the button for approx. 2 seconds to
confirm.
Time
A cursor pre-selects the hours of the time. Press briefly on the button to change
the hour until the actual hour is shown. Please hold the button for approx.
2 seconds to confirm the hour. Please continue with the minutes in the same
way: short press to change and long press to confirm.
Measurement unit
A cursor pre-selects a measurement unit in the list. Press briefly on the button to
change the position of the cursor in order to select your needed measurement
unit. If the cursor selects the needed measurement unit, please hold the button
for approx. 2 seconds to confirm.
After the setup wizard is finished, the display shows Welcome and continues with
READY for tests.
®
The Alcotest 4000 is now adjusted to your settings and is ready for breath tests.
Of course these and further settings can be adjusted in the device menu (see
Section 4.6 on Page 9).
NOTICE
Loss of default settings
If the battery replacement process takes longer than 5 minutes, the date and
time must be reset. A measurement is only possible with the time set.
4.3

Carrying out a breath sample

A new mouthpiece must be inserted for each person who provides a breath
test.
For hygiene reasons, hold the mouthpiece only on the grip zones.
Do not allow any high alcohol concentrations on the sensor, e.g., by rinsing
the mouth with a high proof alcohol shortly before the measurement, as this
will shorten the service life of the sensor.
en
Use
7