Joie i-Snug 2 Manual De Instrucciones página 11

Head Support and Shoulder
Harnesses
see images -
16 17
1. The head support can be adjusted according to the baby's height.
16
2. Check that shoulder harness straps are set at the proper height.
!
No matter where the head support is, the bottom of head support
must be level with the highest point of child's shoulder, it is shown
as 17
!
If the shoulder harness straps are not at proper height, the child
might be ejected from the enhanced child restraint if there is a crash.
Securing Child
in the Enhanced Child Restraint
see images -
18 23
Note
1. Infant insert is for children's protection. Children whose height
is under 60cm are suitable to use the infant insert.
2. Before using the insert, please add the foam wedge.
Remove the body portion of the infant insert when
the infant's shoulders no longer fit comfortably.
9
1. While pressing the harness adjustment button, pull completely the
two shoulder harnesses of the enhanced child restraint.
2. Unlock the buckle of the harnesses by pressing the red button.
3. Place child into the infant carrier module and lock the buckle.
4. Tighten the shoulder harnesses by pulling adjustment webbing.
Detaching Canopy and Seat Pad
see images
To re-assemble the soft goods, reverse the aforementioned steps.
Installation without base
see images
!
DO NOT install this infant carrier module on vehicle seats with Lap
Belts.
!
This infant carrier module is suitable for vehicle seats with a 3-point
Retractor Safety Belt only.
1. Place the infant carrier module onto the vehicle seat where you wish
to put it. Pull the vehicle safety belt out and lock it into the vehicle
buckle, sliding the vehicle lap belt into the side guides of the infant
18 carrier module.
!
The infant carrier module can not be used if the vehicle safety belt
buckle (female buckle end) is too long to anchor the infant carrier
module securely.
2. Slide diagonal belt into the rear guide.
3. Pull the vehicle shoulder belt to fasten the infant carrier module
tightly and securely.
4. Level line on infant carrier module must be level to the ground when
the infant carrier module is installed.
!
Tension the vehicle safety belt as much as possible, checking that it
is not loose or twisted.
-
24 29
-
30 37
30
31
32
-2
32
34
19
20
&
21 22
23
33
35
10