Ferm FAT-850 Manual De Instrucciones página 3

38
TYRE INFLATING GUN WITH PRESSURE
GAUGE
First check de pressure of the object (use the pressure
gauge on the blow gun)
• Connect the coupling of the gun with the valve of the
object
• Read the pressure on the gauge:
- Pressure too high: press the button on the left
side to release air.
- Pressure too low: press the trigger to fill the
object till required pressure.
• Check pressure by releasing the trigger and read the
pressure gauge.
• Disconnect the tyre inflating gun.
AVERAGE PRESSURE
OBJECT PRESSURE (PSI) PRESSURE (Bar)
Soccerball 13
Basketball 9
Volleyball 5
Lawn-tractor tyre 20
Air bed hard
Bicycle tyre 75
Check the service-manual of your car for the
correct tyre pressure of your car.
AIR BLOW GUN
Always be aware of small particles which can release and
cause injury. Do not point the blow gun towards yourself
during cleaning activities.
AIR ENGINE CLEANING GUN
The air engine cleaning gun can be used for spraying
liquids. For example to maintain rust-sensitive materials
such as garden tools.
• Pour the liquid into the cup
• Connect the cup to the air engine cleaning gun
• The flow can be adjusted by rotating the nozzle. The
nozzle can be blocked with help of the locknut.
• Always clean the gun after every use.
TROUBLESHOOTING
Spray gun does not spray / blow gun does not
blow
1. Check the valve, cylinder and needle of the nozzle on
blockage
2. Check the air hose on leakage
3. Check the air pressure
"Orange Skin" excessive fogging.
1 Incorrect solvent is used
Use correct solvent.
2 Spray gun too far from the surface.
Hold spray gun closer to the object.
3 Paint too thick
Thin the paint
Ferm Ferm
Tyre inflating gun: no air flow
1. Check the air pressure
2. Check hose connector (connected correctly?)
3. Check the air hose on leakage
GUARANTEE
For the conditions of guarantee, please refer to the
separately provided guarantee card.
ı
CE
DECLARATION OF CONFORMITY
We declare under our sole responsibility that this
product is in conformity with the following standards or
standardized documents
0.8 EN983
0.6
0.3 in accordance with the regulations.
1.3
hard 97/23/EG
5
from 01-01-2005
ZWOLLE NL
W. Kamphof
Quality department
( UK )
3