First Use Preparation And Set-Up - mspa P-MB049 Manual De Instrucciones

REF. NO.
A
B
C
D
E
F
G
H
I
J
K
L
M
NOTE: When ordering parts, be sure to quote the model number and description.

FIRST USE PREPARATION AND SET-UP

Site preparation and requirements
● The spa can be installed indoors and outdoors. For household use only.
● The spa must be set up on a flat, smooth, and firm surface that is capable of supporting the maximum load
of the filled spa with the listed number of maximum occupants.
● Make sure the area is free of sharp objects under or around the spa. Uneven or unsound surfaces can
damage the spa and void your warranty. Level the surface before filling the spa with water.
● Provide adequate drainage system around the spa to deal with overflowing water and splashes.
● Make sure there is enough clearance around the spa for full access to the spa equipment for maintenance
and/or service.
Additional requirements for indoor installation
● Verify the floor can support the filled weight of spa with the maximum number of occupants. Check with a
qualified contractor or structural engineer to verify the requirement.
● Make sure the floor is water resistant and provides a non-slip surface. Do not install the spa on a carpet of
any other material that could be damaged by the moisture.
● Humidity is a naturally side effect of indoor spa installation. The room shall be properly ventilated to allow
moisture to escape. Install a ventilating system to prevent excess condensation moisture in the room.
PARTS DESCRIPTION
Spa cover with aluminum foil inside
(Soho P-SH069 comes with a ground mat with the cover)
Heat preservation bubble mat (For P-MB049/069 / P-CA049/069)
Heat preservation foam mat (For P-EX049/069)
Digital lock (except for Soho P-SH069)
Inflation hose for bladder
Filter cartridge*2, cartridge base
Spa drain valve adaptor
Buckle spa cover and ground mat set (only for P-SH069)
Spa tub
Wired controller
Repair kit
Inflatable bladder
Wrench
11
QTY.
1
1
1
1
1
1
1
1
1
1
1
1
1