Sanus Systems VMAA18 Instrucciones De Montaje página 3

All manuals and user guides at all-guides.com
Assembly Instructions for Model: VMAA18
Thank you for choosing a Sanus Systems VisionMount™ wall mount. This model will hold 30 - 50 inch Plasma and LCD TVs weighing
up to 130 lbs to a vertical wall. It is a full motion mount that will tilt, swivel, extend and can roll ±6° to level the TV.
Safety Warning: If you do not understand these directions, or have any doubts about the safety of the installation, please call a quali-
fied contractor or contact Sanus at 800.359.5520 or www.sanus.com. Check carefully to make sure that there are no missing or defective
parts. Our customer service representatives can quickly assist you with installation questions and missing or damaged parts. Replace-
ment parts for products purchased through authorized dealers will be shipped directly to you. Never use defective parts. Improper instal-
lation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified by Sanus Systems.
Sanus Systems can not be liable for damage or injury caused by incorrect mounting, incorrect assembly, or incorrect use. Please call
Sanus Systems before returning products to the point of purchase.
Required Tools: 3/16" drill bit, wrench set, phillips screw driver
Supplied Parts and Hardware: Some parts not shown at same scale*
(1) Wall Plate - a (1) Arm Assembly - b (1) Preventor - c*
(4) Vise Assembly - f *
(2) 1" Diameter Tube - d (2) Monitor Bracket - e
Sanus Systems 2221 Hwy 36 West. St. Paul, MN 55113 11.15.05
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
VMAA18ins_010606_ML.indd 3 1/13/06 3:04:43 PM