Rear Panel Overview - Teac AG-H500 Manual Del Usuario

Rear Panel Overview

1
1Audio signal jacks:
Note:
Make sure that you connect the white pin-
plug to the white jacks (left) and the red
pin-plug to the red jacks (right).
... PHONO input jacks
Connect the output jacks of the record
player (turntable) to these jacks.
... AUX input jacks
Connect the output jacks of the VCR or
other AUXiliary source unit to these
jacks.
... CD input jacks
Connect the output (LINE OUT) jacks of
the CD player (PD-H570) to these jacks.
... MD/TAPE 2 (PLAY/REC) jacks
These jacks are used for the connection
of the MD player (MD-H500) or the
second cassette deck.
Connect the output (LINE OUT) jacks of
the MD player or cassette deck to the
PLAY jacks; the input (LINE IN) jacks of
the MD player or cassette deck to the
REC jacks.
... TAPE 1 (PLAY/REC) jacks
Connect the output (LINE OUT) jacks of
the cassette deck (R-H500) to the PLAY
jacks; the input (LINE IN) jacks of the
cassette deck to the REC jacks.
2 3
2Speaker terminals (see page 3.)
3Antenna terminals
4RESET switch
Press the RESET switch once or twice with
a pencil or a ball-point pen lightly.
... If you press this RESET switch, all the
memories will be erased. In this case, try
to preset stations again.
5REMOTE CONTROL jacks
These jacks are used for the connection of
the TEAC Mini component system (PD-
H570, PD-H500, R-H500) for the purpose of
operating it using the Remote Control unit
(RC-613 provided with the receiver) or
system control signals.
4 5
– 4 –
6 7 8
6AC OUTLETS (unswitched)
Plug the AC power cord of the source unit
(CD player, cassette deck, etc.) into this AC
OUTLETS.
7AC power cord
Plug the AC power cord into an AC wall
socket.
8Main power switch
Press the ON side of this rocker (seesaw)
switch to turn the power ON (standby
position); press the OFF side to turn the
power off.
Note:
Leave the main power switch ON at all
times.