Remote Control Operation - Teac AG-H500 Manual Del Usuario

Remote Control Operation

When operating the remote control unit,
point it towards the remote sensor on the
front panel of the unit.
1
9
0
q
1power standby buttons
on: Press to turn the system on.
standby: Press to set the system to standby
mode.
2Indicator
This indicator will blink when a remote
control signal is transmitted by pressing a
button.
Note:
The indicator has two colors:
One is green in the CD mode; the other is
red in other mode.
3tape deck operation buttons
4Numeric buttons
These buttons are used for selecting the
preset channel in tuner mode, or the track
number in CD mode.
... Using the input selector buttons, select
CD or tuner before operating the
numeric buttons.
When entering a single-digit number, enter
2
0 for the 10's digit followed by the desired
1's digit.
When entering a double-digit number, first
3
enter the 10's digit then the 1's digit.
For example:
4
To enter 15:
(1) Press "1", and "1" starts blinking.
(2) While it is blinking, press "5".
5
5Input selector buttons
6
6tuner operation buttons
band:
Selects between FM and AM broadcasts.
7
preset call:
Allows you to tune to preset channels in
sequence.
7CD player operation buttons
8
8volume buttons
+ : Press to increase the volume.
– : Press to decrease the volume.
9sleep button
This button is used for engaging the sleep
timer in the tuner.
0dimmer button
Press this button when you want to darken
the FL displays on the tuner, CD player and
cassette deck.
Press it again to resume the original
brightness.
qRDS (Radio Data System) mode
button (See pages 12 & 13.)
– 7 –
ª Battery Installation
1. Remove the battery compartment
cover.
2. Insert two "AAA" (R03, UM-4) dry
batteries.
Make sure that the batteries are
inserted with their positive ± and
negative — poles positioned correctly.
3. Close the cover until it clicks.
Battery Replacement.
If you notice that the distance between
the remote control unit and the player for
correct operation becomes shorter, it
indicates that the batteries are exhaus-
ted. In this case replace the batteries with
new ones.
Precautions concerning batteries
... Be sure to insert the batteries with
correct positive ± and negative —
polarities.
... Use batteries of the same type. Never
use different types of
together.
... Rechargeable and non-rechargeable
batteries can be used. Refer to the
precautions on their labels.
... When the remote control unit is not to
be used for a long time (more than a
month), remove the batteries from the
remote control unit to prevent them
from leaking. If they leak, wipe away
the liquid inside the
compartment and replace the batteries
with new ones.
... Do not heat or disassemble batteries
and never dispose of old batteries by
throwing them in a fire.
batteries
battery