System Parameters - Dea NET724 EVO Instrucciones De Uso Y Advertencias

NET724 EVO
rA.09 Memorised remote controls
By selecting this parameter the display will show the number of remote controls saved in the memory. Use the [OK]
button to visualise them.
rA.10 Learning via hidden button
Can be used to enable programming of new remote controls via radio using the hidden button.
• 000: programming deactivated;
• 001: programming enabled, which nonetheless remains disabled if the control unit is locked using the installer
code or the HCS remote control (see SY.07);
• 002: always enabled, even with the control unit locked;
Note: The hidden-button function is nonetheless always disabled with NET-NODE, NET-BOX or NET-COM connected
(ER20 on the display).

SYSTEM parameters (

SY.00 TYPE set
Allows for viewing the TYPE and the fi rmware currently being used.
- Press the [OK] button: the display briefl y shows the TYPE (e.g.: "-04-") followed by the fi rmware version (e.g.:
"00.01").
SY.01 Motor type
Type 00
• 010: LIVI 3/24N
Type 04
• 000: ADVANCE - ADVANCE/N -
SPACE - SPACE/N
• 001: SPACE/L
SY.02 Not Used
SY.03 Encoder used
• 000: motors with wired encoder
• 001: motors without wired encoder (virtual encoder)
SY.04 Encoder type
• 001: Encoder 1 channel
• 002: Encoder 2 channels
SY.05 Restoring the operating parameters (excluding IN / OUT)
Restores the parameters of the control unit to the default values for the set TYPE. Does not modify the values of
the inputs and outputs.
Enter in SY.05 with the [OK] button: [dEF1] will appear fl ashing. Press and hold the [OK] button until [dEF1] stops
fl ashing; Release the [OK] button.
SY.06 Maintenance manoeuvre counter
If=0 it resets the counter and disables the intervention request, if>0 it
indicates the number of manoeuvres (x500) to be completed before the
control unit performs a pre-fl ash of 4 additional seconds to signal the need
to carry out a maintenance intervention.
E.g.: If SY.06=050, the number of manoeuvres = 50x500=25000
Warning: Before setting a new value for the maintenance manoeuvre
counter, the latter must be reset by setting SY.06=0 and only later SY.06=
"new value".
SY.07 Programming access lock
Access to the control unit programming can be locked, so that the parameters cannot be modifi ed through the
display and the buttons. After entering SY.07 two possible messages will appear:
• FREE: no lock active
• BLOC-PROG: lock active
The lock can be set in two modes:
• Insertion with remote control through HCS encoding: within SY.07, press the remote control button to lock/
unlock.
• Installer code setting through NET-LINK devices.
42
)
• 002: ADVANCE/XL - SPACE/XL
• 003: SPACE/XXL - SPACE/N/XXL
• 004: SPACE/N/L BOOST
001 001
Default Default
TYPE 00 TYPE 04
000 004
010 000
• 005: SPACE/N/XL - ADVANCE/N/XL
• 006: SPAZIO 702S
• 007: SPAZIO 703S
000 000
001 002
• 000: Maintenance request disabled
• >000: Number of manoeuvres
(x500) for maintenance request
(1...................................255)