Brandt BHC6601X Manual De Instrucciones página 22

OPERATION
Switch :

REPLACING BULB
Switch off the extractor hood and isolate
1.
the extractor hood by pulling out the
mains plug or switching off the fuse.
Remove the grease filter.
2.
3.
Replace the lamp (commercially)
led modules,separate ballast.
Reconnect the power by inserting the
4.
mains plug or by switching on the
fuse.
Max power
Self-ballasted
LED modules
ON/OFF LIGHTING SWITCH: Press on this switch
to
turn on the lights, and press again to turn them off.
OFF MOTOR SWITCH: Press on this switch to stop
the motor operation.
SPEED SWITCH: Press on this switch, the motor
runs
at LOW speed.
SPEED SWITCH: Press on this switch, the motor
runs at MEDIUM speed.
SPEED SWITCH: Press on this switch, the motor
runs at HIGH speed.
Voltage
1.5W 220-240V
Picture
Square/Diameter:33.2mmx120mm
22
Lamp Cap ILCOS D code
DBS-1.5-
H-33.2/120