UFESA NT3510 Manual De Instrucciones página 20

B&B TRENDS SL. disclaims all liability for damages that may occur to people, animals or
objects, for the non-observance of these warnings.
INSTRUCTIONS FOR USE
CHARGING
Make sure the product is switched o . Insert the small plug into the product and put the
power plug in outlet. Charging takes about 8 hours. After charging, remove the power plug.
Operating time: when the product is fully charged, it has a cordless operating time of up to
30 minutes.
Do not use the device if the miniature blade is bent or damaged.
1. Take the protective cap off the miniature blade.
2. Slide the ON/OFF switch up to switch on the device.
3. Bring the tip of the miniature blade slowly and carefully to the front section of the nostril
or ear.
4. Remove the nose or ear hair carefully, using small, circular motions.
5. When you are finished with the application, slide the ON/OFF switch down to switch off
the device.
6. Place the protective cap onto the miniature blade.
EYEBROW TRIMMING (Fig.1)
You can trim your eyebrows to 3mm or 6mm with the comb attachment provided.
1. Take the protective cap off the miniature blade.
2. The comb attachment is labelled with 3mm on one side and 6mm on the other. Place
the comb attachment onto the miniature blade from above. Make sure that you have
placed the correct side of the comb attachment (3 or 6mm) on the miniature blade. Ensure
that you hear and feel the comb attachment click into place.
3. Slide the ON/OFF switch up to switch on the device.
4. Run the comb attachment over your eyebrow from the outside of the brow inwards
towards your nose.
5. When you are finished with the application, slide the ON/OFF switch down to switch off
the device.
6. Pull the comb attachment up and off.
7. Place the protective cap onto the miniature blade.
You can also trim without attachment.
You can trim the hair under the eyebrows, around the mouth, or all over the body.