Setting The Timer - Klarstein ROYAL FLUSH DOWNDRAFT Manual De Instrucciones

Setting the speed
1. Press the SPEED button to turn the fan on. Press the button again to turn the
fan off. 2.
2. Move your finger over the SLIDER BAR to adjust the speed. The shortest bar
means low speed, the longest bar means high speed.
Bar 1 and 2 = low speed.
Bar 3 and 4 = moderate speed.
Bar 5 and 6 = medium speed.
Bar 7 and 8 = high speed.
Switching on the lighting
Once the hood is extended, the light will automatically turn on after 8-10 seconds,
• Press the LIGHT button to turn the light off. Press the button again to turn the
light back on.
• When you press the LIGHT button to turn on the light, it will flash for a short
time. During this time, you can adjust the light intensity with the SLIDER BAR.
Each strand of the bar represents one of 8 intensity levels. Swipe your finger
across the bar to set the desired intensity. When you have adjusted the light
as desired, wait 15 seconds for the light to stop flashing automatically.

Setting the timer

• While the fan is running, press the TIMER button to set a power off timer.
Swipe your finger across the SLIDER BAR to set a the time: 5-10-20-25-30-40
minutes.
• When you have selected the time, press the TIMER button to confirm or do not
touch any button for 5 seconds, the set time will be automatically applied.
• Once the time is confirmed, the timer will count down the time. When the time
is up, the device will automatically turn off, go into standby mode and shut
down.
• When you use the timer again, it will use the last set time unless you change
the time. After 5 seconds, the timer takes over the set time and starts
counting down.
• If you touch the SPEED or LIGHT keys while the timer is running, the timer will
automatically stop.
EN
33