Installation Notes; Getting Started - Klarstein COACHELLA Manual De Instrucciones

INSTALLATION NOTES

It is important that you leave your device upright for at least 4 hours before
switching it on to allow the cooling system to adjust.
• When you move the unit, do not tilt it more than 45 degrees. Do not apply
force to parts such as the condenser, door or handle. They can distort and
interfere with the operation of the cooler. Make sure ALL packaging is
removed before installation.
• Make sure there is enough space around the product to allow air to circulate
freely.
• Do not place the product near heat sources, in direct sunlight or in humid
rooms.
• Make sure that the supply voltage of the power outlet corresponds to the
voltage indicated on the type plate.
• Insert the plug firmly into the socket.
• The socket outlet must be earthed. Do not plug the plug into unearthed
sockets and do not use an extension cable.
• The product is equipped with adjustable feet. Once the product is in place,
adjust them so that the refrigerator is level and does not slip.
Note: Do not place the product in places where the ambient temperature can
fall below 5 °C, e.g. in the garage or shed.

GETTING STARTED

Notes on Energy Consumption
If the ambient temperature is 25 ° C and the beverage cooler is not filled, it takes
about 30 minutes to reduce the temperature of the beverage cooler from 25 ° C to
17 ° C.
The recommended operating temperature of the beverage cooler is 17 °C. The
energy consumption is 0.233 kWh/24 h.
If the set temperature is higher than 17 °C, the energy consumption is lower. If the
set temperature is lower than 17 °C, the energy consumption is higher.
EN
31