Tips
• Make sure that the Insignia universal remote
control Is operating the device you want to use to
access the streaming service before programming.
• If the macro doesn't work as expected, repeat the
same sequence to try to program it again.
• When programming, wait for your device to
respond. Your remote will remember the timing.
• The app shortcut macro is tied to one device. Make
sure you are watching the correct device.
Understanding and using Activities
Using a standard universal remote control, if you want
to control several different devices you need to press
different device buttons in order to control each
device individually. Using the Insignia universal
remote control, you can create an Activity, with which
you can group a combination of devices and not have
to switch control between them.
For example, if want to control the input of your TV,
the channels and guide of your DirecTV STB, and the
volume of your sound bar, you would need to swap
between these devices by pressing the TV and STB
buttons. On the Insignia universal remote control,
these devices can be grouped into a single Activity. So
by pressing the button for the Watch TV Activity (
the input button will control the TV, the VOL +, VOL -,
and MUTE buttons will control the sound bar, and all
of the other buttons will control the set top box.
There are several devices you can combine.
• Combination 1 – TV + STB + AUDIO (default)
• Combination 2 – TV + STB
• Combination 3 – TV + AUDIO
If you set the default devices for any Activity on the
Insignia universal remote control (for example TV, STB,
and Audio for the Watch TV Activity), that Activity will
be set up automatically on your remote.
If you have set up your remote to control the volume
of a sound bar or audio device (see Controlling the
volume on your sound bar or audio receiver on page
11), the Watch TV Activity will automatically control
the volume of that device.
www.insigniaproducts.com
Three-device Universal Remote
)
,
17