Troubleshooting - Insignia NS-RMT3D21 Guia Del Usuario

You can also program Activities yourself.
1 Press and hold the SETUP button until the LED
under the device button blinks twice. The LED
under the current device button stays lit.
2 Press the Activity button you want to set up (for
example, Watch TV (
3 Press the number of the combination you want to
set (for example 3, for TV + audio in the Watch TV
Activity). The LED blinks twice.
4 Press the Activity button (
controlling by device by using any device button.
Using the AV shift
The INPUT button selects the input on your TV (most
TVs use a menu to select from a list of inputs). When
the INPUT button is pressed in an Activity, the MENU
,
,
seconds) control the TV. If the OK button is pressed, or
no button is pressed for ten seconds, these buttons
revert to controlling the relevant device for the Activity
(for example STB in the Watch TV Activity).
Using the power macro
If you press and hold the
seconds in any Activity, your remote sends the power
signal to each device within that Activity. For example,
pressing the
for the Watch TV Activity turns both the TV and set top
box on or off.

Troubleshooting

CAUTION: Do not try to repair your remote yourself.
Doing so invalidates the warranty.
PROBLEM
The LED does not
turn on when a
button is pressed.
18
, ,
and OK buttons temporarily (10
(power) button in the default setting
SOLUTION
Replace the batteries.
www.insigniaproducts.com
)
).
)
. You can return to
(power) button for two