Setting Up Your Universal Remote Control; Installing The Batteries; Programming And Using Your Remote Control - Insignia NS-RMT3D21 Guia Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Setting up your universal remote control

Installing the batteries

Your remote control requires two AAA batteries.
1 Remove the battery compartment cover from the
back of your remote control.
2 Insert two AAA batteries (not included) into the
battery compartment, making sure that the + and -
symbols on the batteries match the + and - symbols
inside the battery compartment.
3 Replace the battery compartment cover.
CAUTIONS:
• Do not spill water or any liquid on your remote
control.
• Do not place your remote control on a wet surface.
• Do not place your remote control in direct sunlight
or near sources of excessive heat.
• If your remote control is not going to be used for a
long time, remove the batteries to avoid any
damage that may be caused by leakage and
corrosion.

Programming and using your remote control

Your Insignia universal remote control is
pre-programmed to control three of the most popular
devices, right out of the box. If you have one of the
following devices, try putting the batteries in and
pressing the corresponding device button (for
example TV or STB), and then press a few function
buttons to see if your remote controls your device.
PRESS THIS BUTTON
TV
STB
6
DEVICE CONTROLLED
Samsung TV
Comcast Xfinity Set Top Box
www.insigniaproducts.com

Publicidad

Tabla de contenido
loading

Tabla de contenido