universalblue UBLA2804-21 Manual De Instrucciones página 90

The display
shows "UE"
during the spin
cycle.
Display shows
"IE" during
water inlet.
The display
shows "OE"
during water
outlet.
The display
shows "DE"
which is a door
problem.
The display
shows "I:E"
which is a non-
heating
problem.

Check
leakage protector is
cut off.

Check
transport bolts have
been removed.

Is the machine firmly
installed?

Are the clothes too
small or too light?

Are the locking nuts
under the legs tight?

Check if the tap is
turned off.

Check if the water
supply is turned off or
the water pressure is
too low.

Are the water inlet
pipes frozen?

Are the filters blocked?

Are the water outlet
pipes set too high?

Are the water outlet
pipes frozen?

Are the water outlet
pipes blocked?

Is the
blocked?
Check if the washing machine has
started without properly closing
the door.
Remove the plug and call the after-sales service.
whether the
whether the
floor drain
Remove the transport
bolts.
Place the machine on a
stable floor.
Add more clothes.
Tighten the locking nuts.
Open the faucet.
Please wait.
Use hot water to thaw
the pipes.
Remove the filters and
clean them.
Pull out the water outlet
pipes and make sure
that the height is 1m
max.
Use hot water to thaw
the pipes.
Remove foreign
particles and clean the
pipes.
Clean the floor drain.
Check that the door is
properly closed.
90