universalblue UBLAV2702-21 Manual De Instrucciones página 58

 The voltage is within the values indicated on the product label.
 Do not use extension cords or multiple plugs.
 Once the appliance is installed, the power cord and power
outlet should be easily accessible.
 The cable must not be bent or compressed.
 If the power cord is damaged, it must be replaced by the
manufacturer or a professional.
 The company is not responsible for incidents that occur when
the user fails to comply with any of the requirements set out
in this manual.
Once the appliance has been installed, the power supply wire
and the electrical socket should be easily accessible.
The wire should not be bent or compressed.
If the power supply wire is damaged, it must be replaced by
the manufacturer or its Technical Assistance Service in order
to prevent all potential hazards.
The company shall not be responsible for any incidents that
occur if these regulations are not observed.
ADVICE ON THE FIRST WASHING CYCLE
Once the appliance is installed, before starting the first washing
cycle, it must be completely cleaned, fill the salt tank and rinse aid
dispenser. The water may overflow when filling the salt dispenser but
don't worry as this is completely normal. It is also common for the
salt indicator light to continue flashing as low/low for a few cycles
after the dispenser has been filled.
Before starting the dishwasher, check the following:
 If the dishwasher is level and fixed
 If the inlet valve is open
58