universalblue UBLAV2702-21 Manual De Instrucciones página 85

E2 Water inlet
E3 Water drainage Problem in the drainage of the appliance
Temperature
E4 sensor
E5 Overflow
E6 Water leaks
E7 Resistance
If an overflow occurs, disconnect the main water supply
before calling for service. If there is water in the base due to
overfilling or a small leak, the water must be removed before
restarting the appliance.
This device is designed to ensure maximum reliability. However, in
case of problem, you will be able to determine its cause by following
the indications suggested in this manual.
If the problem cannot be solved, please contact the seller or the
manufacturer.
All users should familiarize themselves with this chapter. Knowing
what can go wrong can help you avoid further problems.
Reviewing the charts on the following pages may make you be free
of calling to the technical service:
PROBLEM
Blown fuse
Device
does not The
turn on electrical
current is not
on
Problem with the water inlet of the
appliance
Malfunction in the temperature sensor
Overflow or loss of water from the
appliance
Water leaks from the appliance
The appliance heats up more than usual
POSSIBLE
CAUSES
Replace fuse. Disconnect any other
electrical apparatus that is connected to the
fuse.
Make sure the dishwasher is on and the door
is closed. Make sure that the plug is
connected to the mains.
HOW TO PROCEED
85