Fill With Detergent - universalblue UBLAV2702-21 Manual De Instrucciones

1. Open the dispenser by turning the lid to the left and remove it.
2. Add the rinse aid into the dispenser taking care not to overload it,
as this may cause foam. The volume of the rinse aid container is
about 140 ml.
3. Replace the cover by aligning it with the "open" arrow and turning
it clockwise.
4. Wipe up any spills with a damp cloth.
The rinse aid is released during the last rinse to prevent water
droplets from forming on the dishes, preventing stains or scratches
on the dishes. It also contributes to improved drying.
Your dishwasher is designed to use liquid rinse aid. The rinse aid
dispenser is located inside the door next to the detergent dispenser.
Adjusting the rinse aid dispenser
NOTE: Increase the dosage if there are drops of water or lime
stains on the dishes after washing them. Reduce it if there are
sticky whitish streaks on the dishes or a bluish film on the
glassware or cutlery.

FILL WITH DETERGENT

Detergents are necessary to remove dirt from dishes and cutlery.
The rinse aid dispenser has four or six
settings, depending
purchased.
dispenser at an intermediate point if the
dishes stain or do not dry completely and
increase or decrease the amount of rinse
aid based on your preference.
on
Always start
the model
with the
65