Disconnecting A Cellular Phone; Registering Connected Cellular Phone - Pioneer DEH-P85BT Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operating this unit
# The link code is set to 0000 as default. You
can change this code in the initial setting. Refer
to Entering PIN code for Bluetooth wireless con-
nection on page 52.
Using a cellular phone to initiate a
connection
Putting the unit in Connection open mode al-
lows you to establish a Bluetooth wireless con-
nection from your phone. You may need to
refer to the operation manual that came with
your phone if you are unsure how to initiate a
connection from your phone.
1
Use MULTI-CONTROL to select
Connection open in the function menu.
2
Press MULTI-CONTROL to open the con-
nection.
Always waiting is displayed and the unit is
now on standby for connection from cellular
phone.
3
Use cellular phone to connect to this
unit.
# Operation varies depending on the type of
your cellular phone. Refer to the instruction man-
ual that came with your cellular phone for de-
tailed instructions.
# You may need to enter the link code on your
cellular phone to complete the connection.
# The link code is set to 0000 as default. You
can change this code in the initial setting. Refer
to Entering PIN code for Bluetooth wireless con-
nection on page 52.

Disconnecting a cellular phone

When you are done using your phone with this
unit, you can close the Bluetooth wireless con-
nection.
1
Use MULTI-CONTROL to select
Disconnect phone in the function menu.
Device name of the connected phone appears
in the display.
2
Press MULTI-CONTROL to disconnect a
cellular phone from this unit.
After the disconnection is completed,
Disconnected is displayed.
Registering connected cellular
phone
You can register a phone that is temporarily
connected to this unit in order to take full ad-
vantage of the features available with Blue-
tooth wireless technology. A total of three
phones can be registered.
1
Use MULTI-CONTROL to select
Set phone in the function menu.
2
Push MULTI-CONTROL up or down to
select a registration assignment.
P1 (user phone 1)—P2 (user phone 2)—P3
(user phone 3)
# As you select each assignment, you can see
whether or not a phone is already registered
there. If the assignment is empty, No data is dis-
played. If the assignment is already taken, the de-
vice name appears. To replace an assignment
with a new phone, first delete the current assign-
ment. For more detailed instructions, see Deleting
a registered phone on the next page.
# If you need to know the BD (Bluetooth Device)
address of the phone, push MULTI-CONTROL left
here.
3
Press MULTI-CONTROL to register the
currently connected phone.
When the registration is completed,
Reg. Completed is displayed.
# If the registration failed, Reg. ERROR is dis-
played. In this case, return to step 1 and try
again.
Note
Depending on the type of cellular phone, registra-
tion is available only from a cellular phone. (Refer
to Using a cellular phone to initiate a connection
on this page.)
Section
02
35
En

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido