Fein ABLS1.6E Instrucciones De Uso página 15

OBJ_BUCH-0000000132-001.book Page 15 Tuesday, June 18, 2013 7:46 AM
Changing the tool (ABLS1.6E).
Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
The blades cannot be reground and must always be replaced in pairs.
Replacing the cutter blade (figure 10).
Loosen the screws with the hex key.
When one of the four cutting edges of the
cutter blade is dull, turn the cutter blade by
90° and mount back together.
When all four cutting edges are dull, replace
the cutter blade.
Fig.10
1.
1.
2.
Cutter blade
2.
3.
3.
4.
en
15
Screws
90 x 4
2.