Additional Safety Rules For Sanders - Stanley SSS310 Manual De Instrucciones

14 • ENGLISH
making any adjustments, changing accessories,
or storing power tools. Such preventive safety measures
reduce the risk of starting the power tool accidentally.
d. Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power
tool. Power tools are dangerous in the hands
of untrained users.
e. Maintain power tools. Check for misalignment
or binding of moving parts, breakage of parts and
any other condition that may affect the power
tools operation. If damaged, have the power tool
repaired before use. Many accidents are caused by
poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
5. Service
a. Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
6. Electrical safety
Your tool is double insulated; therefore no earth
wire is required. Always check that the main voltage
corresponds to the voltage on the rating plate.
Warning! If the power cord is damaged, it must
be replaced by the manufacturer, authorized
STANLEY Service Center or an equally
qualified person in order to avoid damage or
injury. If the power cord is replaced by an equally
qualified person, but not authorized by
STANLEY, the warranty will not be valid.
7. Labels on tool
The label on your tool may include the following symbols:
Hz .......
Read
Instructions
W ........
Manual
min .....
Use Eye
Protection
Use Ear
Protection
V ........ Volts
n .......
0
A ........ Amperes
Hertz
...... Class II
Watts
....
minutes
..... Alternating
....
Current
..... Direct
.../min..
Current
No-Load
Speed
FEATURES (Fig. A)
1. On/off switch
2. Lock-on button
3. Dust extraction outlet
4. Sanding base
5. Paper clamp lever
6. Variable speed control knob
Avoid prolonged contact with dust from power
sanding, sawing, grinding, drilling, and other
construction activities. Wear protective clothing and
wash exposed areas with soap and water. Allowing
dust to get into your mouth, eyes, or lay on the skin may
promote absorption of harmful chemicals.
SANDING
Lead based paint
Sanding of lead based paint is Not Recommended due
to the difficulty of controlling the contaminated dust. The
greatest danger of lead poisoning is to children
and pregnant women.
Since it is difficult to identify whether or not a paint
contains lead without a chemical analysis, we recommend
the following precautions when sanding any paint:
Personal safety
f No children or pregnant women should enter the work
area where the paint sanding is being done until all
clean up is completed.
f A dust mask or respirator should be worn by all
persons entering the work area. The filter should
be replaced daily or whenever the wearer has
difficulty breathing.
Note: Only those dust masks suitable for working
with lead paint dust and fumes should be used.
Construction
Ordinary painting masks do not offer this protection.
Earthing
Terminal
See your local hardware dealer for the proper (NIOSH
Safety Alert
approved) mask.
Symbol
f No eating, drinking or smoking should be done in
Revolutions
or Recipro-
the work area to prevent ingesting contaminated
cation per
minute paint particles. Workers should wash and clean up
Before eating, drinking or smoking. Articles of food,
drink, or smoking should not be left in the work area
where dust would settle on them.
ADDITIONAL SAFETY RULES
ADDITIONAL SAFETY RULES
FOR SANDERS