Water Softener - Qilive Q.6598 Manual De Instrucciones

Fig. J:
■ Remove the lower basket. Unscrew the reservoir cap.
■ Place the end of the funnel into the hole. Pour in about
■ Fill the salt container to its maximum limit with water, It is normal for a small amount of water
to come out of the salt container.
■ After filling the container: Screw back the reservoir cap tightly.
■ The salt warning light will stop being after the salt container has been filled with salt.
■ Immediately after filling the salt into the salt container, a washing program should be started.
Otherwise, parts of the appliance may be damaged by salty water.
Note: The salt container must only be refilled when the
comes on. Depending on how well the salt dissolves, the salt warning light may still be
on even though the salt container is filled. If salt has spilled, run a soak or quick program
to remove it.
6.2. Adjusting salt consumption
The appliance is designed to allow for adjustment in the amount of salt consumed based on the
hardness of the water used. This is intended to optimise and customise the level o f salt consumption.
Follow the steps below for adjustment in salt consumption.
■ Switch on the appliance.
■ Press for more than
■ Press to select the proper set according to your local environment, the sets will change
in the following sequence:
■ Press to end the set up mode.
Water hardness
German dH French fH British Clarke
0 – 5 0
6 – 11 10 –
12 – 17 21 –
18 – 22 31 –
23 – 34 41 –
35 – 55 61 –
1°dH=1.25 °Clarke=1.78

6.3. Water softener

■ The water softener must be set manually, using the water hardness dial.
■ The water softener is designed to remove minerals and salts from the water, which would have
a detrimental or adverse effect on the operation of the appliance. The more minerals there are,
the harder your water is.
■ The softener should be adjusted according to the hardness of the water in your area. Your
local Water Authority can advise you on the hardness of the water in your area.
5 seconds (within
H1 H2 H3
Mmol/l
– 9 0 – 6 0
20 7 – 14 1.0
30 15 – 21 2.1
40 22 – 28 3.1
60 29 – 42 4.1
98 43 – 69 6.1
°fH=0.178mmol/l Manufactory setting:
1.5 kg of dishwasher salt.
60 seconds after the appliance was switched on).
H4 H5 H6.
Water softener
– 0.94
– 2.0
– 3.0
– 4.0
– 6.0
– 9.8
19
indicator in the control panel
Salt consumption
level (gram/cycle)
H1
H2
H3
H4
H5
H6
H3
0
9
12
20
30
60