Moving The Appliance; Troubleshooting - Qilive Q.6598 Manual De Instrucciones

WARNING!
■ Do not overtighten the filters. Put the filters back in
sequence securely, otherwise coarse debris could
get into the system and cause a blockage.
■ Never use the appliance without filters in place.
Improper replacement of the filter may reduce the
performance level of the appliance and damage
dishes and utensils.
Spray arms – Clean the spray arms regularly (hard water chemicals will clog the spray arm
■
jets and bearings):
– Remove the upper spray arm: Hold the nut in the centre still. Rotate the spray arm
counterclockwise to remove it (Fig. V).
– Remove the lower spray arm: Pull out the spray arm upward (Fig. W).
– Wash the spray arms in soapy and warm water. Use a soft brush to clean the jets. Reinsert
the spray arms after rinsing them thoroughly (Fig. W).
8.4. Frost precaution
Take frost protection measures on the appliance in winter. Every time after washing cycles, operate
as follows:
■ Cut off the electrical power to the appliance at the supply source.
■ Turn off the water supply and disconnect the water inlet pipe from the water valve.
■ Drain the water from the inlet pipe and water valve.
■ Reconnect the water inlet pipe to the water valve.
■ Remove the filter at the bottom of the tub and use a sponge to soak up water.

8.5. Moving the appliance

If the appliance must be moved, try to keep it in the vertical position. If absolutely necessary, it can
be positioned on its back.

9. TROUBLESHOOTING

Problem Possible causes
Error code Longer inlet time.
E1
Error code Overflow.
E4
Error code Equipment problem.
E8
Appliance Fuse blown, or the circuit break
does not tripped.
start
Power supply is not turned on.
Water pressure is low.
Door of appliance not properly
closed.
What to do
Faucet is not opened.
Water intake is restricted.
Water pressure is too low.
Some element of the appliance is leaking.
Contact customer service.
Contact customer service.
Make sure the appliance is turned on and the
door is closed securely. Make sure the power
cord is properly plugged into the wall socket.
Check that the water supply is connected
properly and the water is turned on.
Close the door properly and latch it.
26