Yale PWLCL630SS Guía De Instalación, Uso Y Mantenimiento página 10

Mounting the Hood
The range hood attaches to the wall by the 2 mounting screws in
the wood support mounted to the wall.
1 Using 2 or more people, hang the range hood on the wall by
placing the slotted holes in the range hood back over the 2
screws mounted to the wood support mounted to the wall.
NOTE: If your installation uses the optional duct cover, the vent
system needs to be connected to the range hood and the duct
cover mounted to the top of the range hood before tightening
the mounting screws.
2 Push the range hood up into the narrow slots, align the bottom
of the hood to the horizontal line, level the hood, and tighten
the 2 mounting screws.
3 Mark 2 lower mounting hole center point locations. Drill ¹⁄
(0.32 cm) pilot holes if the holes are located into wood. If holes
are not located into wood, drill two ³⁄
insert 10 x 50 mm wall anchors. Install 2 - 6 x 80 mm screws
with 5.3 x 20 mm washers into the lower mounting anchors and
tighten.
B
C
D
A. Mounting screws
B. 4 screws - 4.2 x 19 mm
C. 2 5.3 x 20 mm washers
D. 2 screws - 6 x 80 mm
4 Install 4 - 4.2 x 19 mm screws through the back of the hood
into the wood support and tighten.
5 Connect vent system to hood. Seal all joints with clamps.
10
" (0.95 cm) pilot holes and
8
A
B
Install Transition
• Install the 10" (25.4 cm) square x 10" (25.4 cm) round vent
transition with damper to top or rear side of the range hood
(depending on your installation), using 4 - 3.5 x 9.5 mm screws.
"
8
NOTE: The exhaust adaptor/damper can be installed up to 1
inch on either side of the hood center to accommodate offcenter
ductwork. In extreme offcenter installations, one end of the duct
connector may need to be trimmed to clear the electrical cable
clamp.
Install Range Hood Internal Blower Motor
1 Remove grease filters from range hood. See the "Maintenance"
section in the Use and Care Guide.
2 Install the range hood blower motor assembly inside the range
hood canopy with the wiring connection to the left for the single
motor system and to the front or top for the dual motor system.
Single blower motor assembly
A
A. Wiring connection
Dual blower motor assembly
A. Wiring connection
A