Electrical Connection; Complete Installation; Description Of The Hood; Control - Yale PWLCL630SS Guía De Instalación, Uso Y Mantenimiento

Ocultar thumbs Ver también para PWLCL630SS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Electrical connection

I WARNING
ELECTRICAL SHOCK HAZARD.
DISCONNECT POWER BEFORE SERVICING.REPLACE ALL
PARTS AND PANELS BEFORE OPERATING. FAILURE TO DO
SO CAN RESULT IN DEATH OR ELECTRICAL SHOCK.
• Remove the knockout and the Junction box cover and install
the conduit connector (cULus listed) in junction box.
A
B
C
D
A. White wires
B. Black wires
C. UL listed wire connector

Complete installation

Replace filters and check operation of the hood.
If range hood does not operate:
• Check that the circuit breaker is not tripped or the house fuse
blown.
• Disconnect power supply. Check that wiring is correct.
To get the most efficient use from your new range hood, read the
"Maintenance" section.
Keep your Installation Instructions and Use and Care Guide close
to range hood for easy reference.

Description of the hood

1
2
3
1. Blower and light controls
2. LED lamps
12
E
F
D. Green (or bare) and yellow-green ground wire
E. Home power supply cable
F. UL listed or CSA approved ½" strain relief
3
4
3. Grease filter handle
4. Grease filter
• Run 3 wires; black, white and green ,according to the National
Electrical Code and local codes and ordinances, in 1⁄2" conduit
from service panel to junction box.
I WARNING
ELECTRICALLY GROUND BLOWER. CONNECT GROUND
WIRE TO GREEN AND YELLOW GROUND WIRE IN TERMINAL
BOX. FAILURE TO DO SO CAN RESULT IN DEATH OR
ELECTRICAL SHOCK.
• Connect black wire from service panel to black or red in
junction box, white to white and green to green-yellow.
• Close and secure junction box cover.

Control

The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the kitchen.
The hood controls are located on the center side of the hood.
Recessing Knobs
• You can hide control knobs by depressing them until flush with
the hood body.
• Pressing the knobs again will lower the knobs, and enable the
user to operate the lights and blower.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pwlcl136ssPwlcl148ss

Tabla de contenido