Using The Timer; Other Features - Qilive Q.6117 Manual Del Usuario

To change the power mode, follow the steps below:
FR
EN
1. Press the MODE knob. The heater will display the current power mode (H1/H2/H3)
on the LED display for 3 seconds.
2. While H1/H2/H3 is displayed, turn the MODE knob to cycle through H1, H2 and H3.
3. When your desired power mode appears, press the MODE knob or wait 3 seconds
to activate the new power mode.
You can press the MODE knob to view the current power mode at any time.
5.3.4 Using ECO mode
The heater can be set to operate in ECO (economical) mode. In this mode, the heater
adjusts its working mode automatically based on the ambient temperature to lower
energy consumption.
To put the heater into ECO mode, press the ECO mode button.
• In ECO mode, the set temperature is displayed using a 2-digit number followed by
the capital letter E. For instance, if the set temperature is 20°C, you will see
displayed.
5.3.5 Using anti-frost mode
The heater can be set to operate in anti-frost mode. This mode is useful in areas such as
garages to prevent frost damage. In this mode, the heating element will cycle on and off
to maintain an ambient temperature of approximately 5°C to help protect against frost.
To put the heater into anti-frost mode, turn the MODE knob all the way anticlockwise until
you see on the LED display.
5.3.6

Using the timer

You can set the timer to allow the heater to work for only a preset number of hours
(1 to 24).
To set the timer, follow the steps below:
1. Press and hold the MODE knob for 3 seconds. The heater will display the preset
number of hours (00
2. While the preset number of hours is displayed, turn the MODE knob to cycle through
the numbers of hours (0 to 24).
3. When your desired number of hours (1 to 24) appears, press the MODE knob or wait
3 seconds to start the timer.
Tips:
• After you start the timer, the heater displays the preset number of hours (1 to 24)
and continues to work using the previous settings. Note: The heater will not display
the remaining time of the timer.
• When the timer is running, you can change the heater's settings such as set
temperature and power mode as described in the previous parts of this user manual.
Changing those settings will not affect the timer.
• When the timer ends, the heater will automatically enter anti-frost mode.
• To end the timer immediately, press the power button or press and hold the MODE
knob for 3 seconds.
5.3.7

Other features

Memory function
If you turn off and/or unplug the heater, the heater will return to its last status (working
mode & temperature) once you turn it on again. Note: This is not applicable to the timer
setting.
) on the LED display and blink the time unit (H) for 3 seconds.
H
10