Maintenance And Cleaning - Qilive Q.6117 Manual Del Usuario

Overheat protection
The heater is fitted with an overheat protection switch (thermal cutout) that will power off
the heater automatically in case of overheating. If this occurs, follow the steps below to
resolve the problem:
1. Unplug the heater and allow it to cool fully.
2. Check and remove the source of the overheating such as poor ventilation and item
covering the heater.
3. Follow the operation instructions to restart the heater.
4. The heater should function normally again. If the problem persists, contact our
Customer Service for advice.
Tip-over protection
The heater is fitted with a tip-over switch that will cut off the power to the heater if it is
tipped over. If this occurs, follow the steps below to resolve the problem:
1. Unplug the heater and allow it to cool fully.
2. Place the heater back on a flat, level and stable surface.
3. Inspect the heater for damage.
4. If and only if the heater is free from damage, follow the operation instructions to
restart the heater.
5. The heater should function normally again. If the problem persists, contact our
Customer Service for advice.
Display auto-dimming
If no action is taken by the user, the LED display will go dim automatically after 60 seconds
to lower energy consumption.

6. MAINTENANCE AND CLEANING

Cleaning
Over time, dust can accumulate on and inside the heater, which can affect its performance.
We recommend that you clean the heater at least once a month.
1. Turn the heater off and disconnect it from the power supply.
2. Wait until the heater has completely cooled down.
3. Wipe the surface of the unit with a soft damp cloth. Mild detergent can be used for
any stubborn marks.
Notes:
• Do not use harsh detergents, chemical cleaners or solvents as they may damage
the surface finish of the heater.
• Never immerse the heater in water.
• Do not allow water or other liquids to run into the interior of the heater, as this could
create a fire and/or electrical hazard.
• We also recommend the periodic cleaning of the heater by lightly running a vacuum
cleaner nozzle over the guards to remove any dust or dirt that may have accumulated
inside or on the heater.
• Ensure the heater is dry before plugging it in again.
WARNING: Do not attempt to open the casing of the heater at any time. There are no
user-serviceable parts.
Storage
If you will not use the heater for an extended period, after cleaning it, please:
1. Ensure you have turned the heater off and disconnected it from the power supply.
2. Cover the heater and store it upright in a dry location where it will not receive direct
sunlight. Note: Prolonged exposure to direct sunlight will discolour the unit.
11 11
R E N F