Tabla de contenido
Publicidad
• This product has been designed for domesic and indoor use only.
The manufacturer will accept no responsibility and the gua-rantee
will be terminated, if this product is used for commercial purposes,
inappropriate use or failure to comply with the instructions.
WHAT WATER TO USE?
Your appliance was designed to operate using untreated tap water.
However, it is necessary to periodically clean the steam chamber to
remove any mineral deposits. If your water is very hard (above 30°f or
17°dH or 21°e) mix 50% untreated tap water with 50% demineralised
water (available in hardware stores).
TYPES OF WATER NOT TO USE?
Do not use water with additive, pure demineralised or pure distilled
water, water from clothes dryers, scented or softened water, rain water,
filtered, bottled or boiled water, water from refrigerators, batteries,
air conditioners or rain water as these may damage the iron. These
types of water contain organic waste, mineral elements that become
concentrated when heated and cause spitting, brown staining, leaking
or premature wear on your iron
ENVIRONMENT
Environment protection first !
Your appliance contains valuable materials which can be
i
recovered or recycled.
Leave it at a local civic waste collection point.
6
If there is a problem?
PROBLEM
POSSIBLE CAUSE
Water drips from the
You are using steam while
holes in the soleplate.
the iron is not hot enough.
You are using the shot of
steam button too often.
You have stored the iron
horizontally, without
emptying it and without
setting it to .
Brown streaks come
You are using ironing
through the holes in the
water additives (i.e.
soleplate and stain the
scented water, starch).
linen.
You are not using the
right type of water.
Your linen has not been
rinsed sufficiently or
you have ironed a new
garment before washing
it.
The soleplate is dirty
Your are ironing with an
or brown and can stain
inappropriate temperature
the linen.
selection (temperature
too high).
You have ironed over a
printed area of a garment.
There is little or no
The water tank is empty.
steam.
Your iron has been used
dry for too long.
Valve pin is not correctly
in place.
Thermodial is not set to
steaming area.
The soleplate is
You have placed your iron
scratched or damaged.
flat on a metallic rest-plate
or ironed over a zip.
Steam or water come
The steam control is not
from the iron as you
set to the DRY
finish filling the tank.
The water tank is
overfilled.
The spray does not
The water tank is not filled
spray.
enough.
SOLUTION
Wait until the thermostat light
goes out.
Wait a few seconds between
each use of the button.
See the section "Iron storage".
Never use ironing water
additives; these will
permanently damage your
steam iron.
Perform a Self cleaning
operation and consult the
chapter "What water to use?".
Make sure that your laundry is
rinsed sufficiently in order to
remove any deposits of soap
or chemical products on new
clothes.
Clean the soleplate (refer
to chapter 9). Select the
appropriate program.
Never iron over printed areas
or applications – always iron
the reverse side of such a
garment.
Fill the water tank.
Carry out a Self clean.
Make sure valve pin is in
correct position.
Set thermodial between 2dot
and Max.
Refrain from ironing over
metallic buttons or zippers.
Check that the steam control is
position.
set to the DRY
position.
Never exceed the Max level.
Fill up the water tank.
7
Publicidad
Tabla de contenido
