Burner Ignition; Turing The Burners Off; Turning The Pilot Light Off; Filling The Tub - Fagor SB-G910 Instrucciones De Instalación, Uso Y Mantenimiento

5.2.2

Burner ignition

•
Pilot ignition G-900:
o
Turn the Mt thermostat control clockwise to the pilot position
indicating that the pilot is ready to be lit (above figure).
o
Next press the solenoid valve control Mv, while turning it anticlockwise to the pilot position
. Hold the control pressed in this position until the pilot flame remains lit (approximately
20 seconds) (above figure).
•
Burner ignition G-900:
o
Pressing the solenoid valve control Mv, turn it to the burner ignition position, leaving it
ready to light the burners.
o
To ignite the burner, press and rotate the thermostat control Mt clockwise to the required
position. At this moment, the L2 lamp will light, indicating that the burners are functioning.
o
When the water in the tub reaches the selected temperature, the burner will turn off by
means of the thermostat (lamp L2 turns off). Also, as soon as the temperature drops
below the selected value, the burner will light up (switching on the L2 lamp).
•
Pilot ignition SB-G710
o
Turn control M anticlockwise to the position Pilot
o
Then press the Piezo Electric.
o
If the pilot does not light automatically, it is possible to light it manually through the ignition
pipe.
•
Burner ignition SB-G710
o
To ignite the burners, press the control and rotate anticlockwise to the required position.
o
When the water in the tub reaches the selected temperature, the burners will turn off by
means of the thermostat. Likewise, as soon as the temperature drops below the selected
value, the burners turn on.
(*) Approximate temperature values
5.2.3

Turing the burners off

•
Turn the Mv valve control to the position Pilot
5.2.4

Turning the pilot light off

•
Turn the Mv valve control to the Off position .
•
Turn the Mt thermostat control to the Off position .
5.2.5

Filling the tub

•
The tilting bratt pan has a filler tap built into the tub, which is controlled by control A.
•
To fill, turn control A to position
5.2.6

Tub drainage

•
Motorised versión:
o
The tilting bratt pan has a motor for tilting the pan, activated using the buttons V.
Control A
.
Control Mt
. Now lamp "L1" lights up,
and hold button down.
, only the pilot will be lit.
36