Operation; Description Of The Controls; Burner Ignition; Turing The Burners Off - Fagor F-G9115 Instrucciones De Instalación, Uso Y Mantenimiento

5.2

Operation

Instructions for the correct use of the appliance:
Never start up the appliance without having previously filled the tub, otherwise
overheating would seriously damage the machine.

Reponer el aceite cuando baje del nivel indicado en la cuba.

Se recomienda introducir lentamente el cestillo con la carga en el aceite para que la espuma
resultante al freir no desborde por la parte superior de la cuba.
It is essential that the chimney does not get blocked, even partially, for the correct
operation of the burners.
The steps required to optimise the operation of your fryer are shown below, with all the available
options.
5.2.1

Description of the controls

1. Gas control
2. Green pilot light
3. Amber pilot light
5.2.2

Burner ignition


Pilot ignition
Turn the Mt thermostat control clockwise to the pilot position
o
indicating that the pilot is ready to be lit (above figure).
Next press the solenoid valve control Mv, while turning it anticlockwise to the pilot position
o
20 seconds) (above figure).

Burner ignition
Pressing the solenoid valve control Mv, turn it to the Burner ignition position, leaving it ready
o
to light the burners.
To ignite the burners, press and turn the thermostat Mt knob (Fig. 6) clockwise until the
o
required position. At this moment the L2 lamp will light, indicating that the burners are
functioning.
When the oil in the tub reaches the selected temperature, the burners will turn off by
o
means of the thermostat (lamp L2 turns off). Also, as soon as the temperature drops below
the selected value, the burners will light up (switching on the L2 lamp).
5.2.3

Turing the burners off


Turn the Mv control to the position Pilot
5.2.4

Turning the pilot light off


Turn the Mv valve control to the Off position.

Turn the Mt thermostat control to the Off position.
5.2.5

Oil drainage

The oil should be filtered regularly, in order to preserve it better.
. Hold the control pressed in this position until the pilot flame remains lit (approximately
CONTROL
M
, only the pilot will be lit.
. Now lamp "L1" lights up,
CONTROL
A
29