Adjusting Blade Guidance; Adjusting Blade Tension - HOLZMANN MASCHINEN BBS810SMART-G Instrucciones De Servicio

Left side

Adjusting blade guidance

Adjusting blade tension

HOLZMANN Maschinen GmbH www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
the horizontal inner nut clockwise around a 1/2
turn.
Then tighten the vertical screws again.
Re-tension the blade and control blade tracking.
Repeat the above steps if further compensation is
required
Adjust rolls of the blade guide in a way that
there is a gap between rolls and blade of a
paper width.
To do this, loosen the screws and adjust the
rolls, then tighten the screws again.
Proper blade tension is achieved if the blade
defects no more than 3-6 mm when it is firmly
moved by hand at the center location of the
blade.
To increase blade tension rotate the lever for the
sawblade tension clockwise.
NOTICE
Make sure the tracking adjustment
bolt is sitting in recess. See Picture.
51
BB810SMART-G