HOLZMANN MASCHINEN BBS810SMART-G Instrucciones De Servicio página 44

HOLZMANN Maschinen GmbH www.holzmann-maschinen.at
10. Assembly clamping bracket/ stops
Insert clamp (30) into clamp holder and
fix with screw (S1).
Insert long stop (37) on log support and
fix with screw. Insert the short stop (27)
into the holder and also fix it with
screws (S1). The angular position of the
stops on the log support can be
adjusted using the two screws (S2).
11. Assembly locking device saw blade
protection
Fix the locking device (1) to the
safety cover (3) and tighten it (2
screws + stop nut).
Attach the locking device (2) to the
fixed saw blade guard (3) and
tighten (2 screws + stop nut).
Close cover and carry out the fine
adjustment of position (2) to (1) and
then tighten locking device (2).
Carry out on both sides.
12. Control of the sawblade distance. If
this is not identical on the left and
right, it must be adjusted at the
rear handle to either raise or lower
one side.
13. Assembly throttle lever on handle
Assembly throttle lever (1) by
means of clamp (3) and
screws/nuts (4) on the pull/push
handle (2).
ASSEMBLY
44
BB810SMART-G