Replacing The Transmitter Battery - Trust ACDB-8000BC Manual Del Usuario

5C
As soon as the transmitter has been paired, the wireless
doorbell will give 2 short beeps. The transmitter,
melody and volume are now paired to the transmitter.
The wireless doorbell is now ready for use.
The doorbell can store 32 different transmitters in its
memory. If you want to pair multiple transmitters,
you need to repeat steps 3 to 5c.
6A Mount transmitter with double-sided tape
.
Determine where the transmitter will be placed and mount
the bottom of the transmitter with the supplied double-
sided adhesive tape.
6B. Mount transmitter with supplied screws
Determine where the transmitter will be placed and mount
the bottom of the transmitter with screws.
7. Close push button transmitter
Press the top half onto the bottom half. Both halves will
only close if the recesses in the lower right corner match.

Replacing the transmitter battery

A
For example, insert a coin into the notch in the lower
right corner to open the transmitter. Carefully make
a twisting movement and click both halves apart.
B
Place a new 12V A23 alkaline battery in the holder.
Pay attention to the correct polarity.
C
Press the top half back onto the bottom half.
Both halves will only close if the recesses in the lower
right corner match.
ACDB-8000BC TRANSMITTER + PLUG-IN DOORBELL
Unpair a Trust Smart Home transmitter
A
Press the connect button for 1 second. The learning
mode will be active for 10 seconds and the LED indicator
on the receiver will flash slowly.
B
While the learning mode is active, send an ON signal
with the transmitter of the linked Trust Smart Home
transmitter that you want to unpair
C
As confirmation, the wireless doorbell gives 2 short
beeps.
Clear entire memory
A
Press the connect button (approx. 8 seconds) until the
LED indicator starts flashing quickly. The reset mode will
be active for 10 seconds and the LED indicator on the
receiver will flash quickly.
B
While in reset mode, press the learn button again for
1 second to confirm that you want to completely erase
the memory.
C
As confirmation, the wireless doorbell gives 2 short
beeps.
Combine transmitter with the Internet
Control Station (ICS-2000) or Smart Bridge
Combine the push button transmitter with the Internet
Control Station (ICS-2000) or Smart Bridge and also receive
a push notification on your smartphone when the doorbell
rings.
For example, you can switch off the wireless doorbell
in the evening and only receive a push notification when
the doorbell is pressed.
EN
9