Initial Startup Primus 2 H1N; Power Supply Safety Instructions; General Power Supply Notes; Operating The Laser With Rechargeable Batteries - Nedo PRIMUS2 H1N+ Manual De Instrucciones

EN Operating instructions
26
5

5.1 Power supply safety instructions

WARNING!
CAUTION!

5.2 General power supply notes

5.3 Operating the laser with rechargeable batteries

5.4 Operating the laser with batteries

ENVIRONMENT

Initial Startup PRIMUS 2 H1N+

Destruction! Explosion risk!
f Use charger included in the scope of delivery only.
f Do not insert batters in the rechargeable battery pack and charge with the charger.
Damage!
f Do not mix dead and fully charged batteries.
f Do not place rechargeable batteries or batteries on radiators or store them in the sun.
Use the charger in dry rooms only.
Rechargeable battery
Connect charger
pack is pushed in
When delivered, the rechargeable battery pack is inserted, the laser is ready
for use. Replace rechargeable battery pack. as follows:
Release rechargea- Pull out rechargeable
ble battery pack / battery pack / batte-
battery compartment ry compartment
locking device
Lock battery com-
partment
Batteries are special waste and may not be put into domestic waste. They must be
properly disposed of according to the respective national guidelines.
1 Connect charger to rechargeable battery
pack.
2 Connect charger to mains supply.
Note voltage! (110-230 V)
Charging time for complete charging:
12-14 h.
During charging, the LED above the char-
ger socket lights up in the rechargeable
battery pack.
Operation possible during the charging
process (charging time lengthened).
Note pole position!
Insert batteries into Push in battery
battery compartment compartment