Klein Tools MM450 Manual De Instrucciones página 10

ENGLISH
AC/DC VOLTAGE (LESS THAN 600V)
1. Insert RED test lead into V jack
COM jack
setting.
NOTE: The meter defaults to AC measurement. Press the "SEL"
button to toggle between AC and DC modes. "AC "or "DC" on the
10
LCD indicates which mode is selected.
2. Apply test leads to the circuit to be tested to measure voltage.
The meter will auto-range to display the measurement in the
most appropriate range.
NOTE: If "–" appears on the LCD, the test leads are being applied
to the circuit in reverse polarity. Swap the position of the leads to
correct this.
NOTE: When in a voltage setting and the test leads are open,
readings of order mV may appear on the display. This is noise and
is normal. By touching the test leads together to close the circuit
the meter will measure zero volts.
NOTE: The Hazardous Voltage indicator appears for voltages >30V.
10
OPERATING INSTRUCTIONS
, and rotate function selector switch
4
Black lead
Red lead
, and BLACK test lead into
5
to the V
2