Diode Test - Klein Tools MM450 Manual De Instrucciones

ENGLISH
CAPACITANCE
1. Insert RED test lead into V jack
COM jack
4
Capacitance/Diode
NOTE: The meter defaults to Capacitance testing in this mode.
Ensure that the display reads "0 nF" with test leads open. If not,
press the "SEL" button
2. Remove power from circuit.
3. Measure capacitance by connecting test leads across the
capacitor. The meter will auto-range to display the measurement
in the most appropriate range.

DIODE TEST

1. Insert RED test lead into V jack
COM jack
4
Capacitance/Diode
NOTE: The meter defaults to Capacitance testing in this mode. To
enter Diode testing mode, press the "SEL" button
Diode icon
2. Touch test leads to diode. A reading of 200-700mV on display
indicates forward bias, "OL" indicates reverse bias. An open
device will show "OL" in both polarities. A shorted device will
show approximately 0mV.
14
OPERATING INSTRUCTIONS
, and rotate function selector switch
setting.
once.
10
Black lead
Red lead
, and rotate function selector switch
setting.
will appear on the display.
Black lead
Red lead
, and BLACK test lead into
5
, and BLACK test lead into
5
10
to the
2
to the
2
once. The