Klarstein MOJAVE S 500 Manual De Instrucciones página 24

EN
WIFI reset
Turn on the heater and long press "WIFI" button for 5 seconds until the WIFI
indicator starts to flash to reset the Wifi connection.
WIFI function ON/OFF
Turn on the heater and long press "Timer" button on the control box for 10
seconds to deactivate the WIFI function of this heater and the WIFI sign on the
screen will disappear, long press "Timer" button for 10 seconds to activate it on
again.
Temperature calibration
Turn on the heater and long press "+" button on the control box for 5 seconds to
enter the temperature calibration, adjust the number by pressing "-" or "+" button,
the calibration ranges from -5 to +5 degrees.
Manual control:
You can always use the remote controller or button on the control box to manually
control your heater and lighting system.
To turn on/off the heater, please press the "Heating On/off button". To set the
desired room temperature, please press "+" or "-" button. To set the count-down
timer for the heating, please press the "Timer button" and adjust the number
by pressing "+" or "-" button.
To turn on/off the lighting, please press the "Lighting On/off" button.
To change the color of the lighting, please press the "Color selection button".
To adjust the brightness of the lighting, please press the "Brightness adjustment
button", each press you are able to change 20% of the brightness.
Please be noted when use the remote controller, make sure the remote controller
is pointing to the Remote control signal receiving point on the control box.
24