Mafell Guiding device L Instrucciones De Funcionamiento Y Seguridad página 9

Guiding device L/M/ML/S
6. Set the desired machining depth and angle of
inclination on the machine.
7. Switch on the machine.
8. Push the machine steadily forward in working
direction.
9. Switch off the machine after you have finished
machining the workpiece.
For separating cuts:
➢
Risk of damaging the cut edge when
retracting the machine during a separation
cut. After the separation cut, move the
machine a little sideways away from the
cut edge before retracting the machine to
the starting position.
10. Pull the machine back to the starting position
while it remains on the workpiece.
This ensures that the lower movable guard
➢
closes completely. A yellow sticker on the
guiding device indicates the starting
position. The machine is in the safe
starting position when you pull it back
behind the mark (in the direction of SAFE).
11. Remove the machine from the workpiece when
it is in this position.
Machining with the guiding device is
✓
completed.
06/2021
Fig. 6: Using the machine with the guiding device
9