Battery Selection; Input Protection; Transport, Packaging And Storage; Transport - WIKA Obsolete CEP1000 Manual De Instrucciones

4. Design and function / 5. Transport, packaging and storage

4.4 Battery selection

The CEP1000 is operated with a normal 9 V alkaline battery or optionally with a
rechargeable 9 V Ni-Cd battery. For the most application cases the alkaline battery with
9 V is sufficient. However, for the intensive use the 9 V Ni-Cd battery is the better choice.
The Ni-Cd battery for 9 V available optionally with an output current of 12 mA and full
battery enables continuous operation for approx. 3 hours (the alkaline battery lasts
approximately 12 hours). The optionally available charging device charges the battery
over night (10 to 12 hours long) and powers the instrument in the stationary mode. At
the same time the conservation charging of the Ni-Cd battery is carried out.
WARNING!
Never connect the power supply unit/charging device if a 9 V alkaline
cell is inserted.

4.5 Input protection

The device has an input protection without a fuse for up to 250 V of direct or alternating
current for the period of time of up to 30 seconds.

5. Transport, packaging and storage

5.1 Transport

Check loop calibrator for any damage that may have been caused by transport.
Obvious damage must be reported immediately.

5.2 Packaging

Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change
in installation site, sending for repair).

5.3 Storage

Permissible conditions at the place of storage:
Storage temperature: -20 ... +70 °C
■
Humidity: 0 ... 90 % relative humidity (no condensation)
■
Avoid exposure to the following factors:
Direct sunlight or proximity to hot objects
■
Mechanical vibration, mechanical shock (putting it down hard)
■
Soot, vapour, dust and corrosive gases
■
Potentially explosive environments, flammable atmospheres
■
WIKA operating instructions, model CEP1000
GB
11