Operation; Startup; Switching On / Off - Mafell FM1000 Instrucciones De Funcionamiento Y Seguridad

5

Operation

5.1 Startup

These operating instructions must be brought to the attention of all persons entrusted with the operation of the
machine, with particular emphasis on the chapter "Safety instructions".
These operating instructions describe only the milling motor. They do not take the installation situation into
account. Please take any other operating instructions into account, too.

5.2 Switching on / off

Use the following procedure to switch on the
machine:
1. Push the power switch (2) forward until it
engages.
After 0.2 s, the milling motor accelerates
➢
with a soft start to the previously
selected rotational speed. The duration
of the soft start depends on the selected
rotational speed. At maximum rotational
speed, it is approx. 1.2 s.
The light at the setting wheel (3) shines
➢
blue.
The machine is switched on.
✓
Use the following procedure to switch off the
machine:
1. Press on the rear end of the power switch (2).
The power switch jumps to the OFF
➢
position.
➢ The light at the setting wheel (3) goes
out and the motor coasts to a standstill.
The machine is switched off.
✓
16
Fig. 7: Switching the machine on
Fig. 8: Switching the machine off
FM1000
01/2022